AnsweredAssumed Answered

Linear actuator in motion study

Question asked by Siva Praneeth on Dec 10, 2011
Latest reply on Dec 13, 2011 by Shrikant Savant

Hello everyone


I have few doubts about motion study.


1)Why does the speed of the linear actuator or rotor remain same even after editing them and changing their respective speeds? Am I only the one experiencing this problem or is there any solution for this?


2)To edit the rotor feature in motion study, direct editing isn't working for me.... I have to create new motion study everytime I want to adjust the speeds.





3) I have created a slot and pin with limit mates for the pin.

     How to impose a linear actuator feature on the pin to oscillate within its limits. I have tried many times and not able to figure out how.
I have attached the image of the motion study of the pin and slot.