7 Replies Latest reply on Nov 25, 2011 4:13 AM by Deepak Gupta

    macro now not working

    Mark Greenwell

      Hi,

       

      Could anyone suggest why the attached macro is now not working.

       

      It was working fine on Tuesday,

       

      Yesterday I upgraded to 2012 sp1 and un - installed SolidWorks 2011 sp4.

       

      Today when I came to use it I get the error message as shown in word doc.

       

      I have attached the point file PM26, i copy these into the macro, have a part file open then click one of the options. This has worked ok up untill now.

       

      Also attached is the X,Y,Z macro.

       

      Thanks

       

      Mark (SolidWorks 2012 sp1)