3 Replies Latest reply on Dec 4, 2011 3:54 AM by Regis WACHEUX

    Thermal Study Response plot greyed out??

    Thimal De Alwis

      Hi everyone,

       

      I am running SW 2010, and using SW Simulation to run a thermal study on an assembly.  I have defined 4 or 5 probes on the thermal plot of the study, and from there I wanted to generate a response curve showing the temperatures of these nodes vs. time.  However, under Probe Result the response button is greyed out and I am not allowed to generate the desired plot.

       

      My study is transient, and not steady-state, so I know this is not the issue.  Furthermore, I took a sub-assembly from this model earlier and took the similar steps, and I was able to generate a Response Plot without any problem.  Does anyone know why this is happening?

       

      I've attached a screenshot too to show what is going on.

       

      Thank you,

      Thimal