After apply forming tool at sheet now by which method i bend this sheet thru sketched curve see image attached.
I don't think that is possible in sheetmetal as there will be multi-curvature geometry. As a workaround you might just model the bended configuration as a solid body...
Good morning Amrit,
Make that bend first then add a sheet metal forming tool that creates that Rib. Don't do the rib first.
how can i apply this type of forming tool after bend?
because this forming impression is in between the right angle bend sheet.
Please explain thru example.
I'm curious about that too...
There was just a post up on this a few weeks ago, I will try to find it.
You can also look on the right side of the screen and it lists similar posts.
Retrieving data ...