I can not design the mold for details! Help me! Thanks
Mold is very simple (straight up&down) for part that you attached. Can you be more specific ?.
I have created parting suface like mold, but can not be........!
Link : http://www.mediafire.com/?k27yliadi7a1sl9
You need to modify the part to change the parting line.
See the picture. The highlighted face should go to cavity and the end gusset need to modify.
Hope this helps
Not sure exactly what your question is - If I undersatnd you correctly
As John showed in his att. image, you need to reverse the draft angle above the parting line (red to blue), then this part should be moldable
Is it a new version of the file that was discussed in this thread: https://forum.solidworks.com/message/246904#246904 ? There you got an example of how to solve a very similar file with the help of "mold tools". It should work to follow the same workflow for this file due to the similarity. But first, as mentioned above, you should solve the draft angles/parting lines so the part is moldable.
Retrieving data ...