Hi everyone,
this one puzzles me a lot.
I'd like to have Bounding Box Length / Bounding Box Width sheet metal part properties into a table in the drawing of that part AND in the BOM of the assembly that part is in.
I can see that properties correctly resolved into FeatureManager -> Cut list -> Cut-List-Item -> Properties, but I cannot make the expression ("SW-Bounding box length@@@Cut-List1@xxxxx.SLDPRT") work anywhere (custom properties, BOMs).
How to?
Thank you
Riccardo
Good morning Riccardo,
I had the same question on here, see these other posts;
https://forum.solidworks.com/message/248220#248220
https://forum.solidworks.com/message/244500#244500
I didn't even get any responce to my question either. I did down load a macro from www.3dcontentcentral.com that works pretty good, however I would still prefer exactly what your asking for. I also think there is a ER on that subject.
Later,
John