0 Replies Latest reply on Oct 18, 2011 4:53 PM by Daen Hendrickson

    Slots and hole table inconsistent behavior

    Daen Hendrickson

      I am using SW2011 with SP3.

       

      I have been creating a series of drawings for very similar parts. Several of the sheet metal parts have slots. The slots all share the same sizing so I have been using copy and paste of the cut feature from part to part (just reattach the dangling items in the sketch). I say this to show that the slot details should produce the same result in the drawings since they are copies of each other.

       

      My drawings' hole table recognizes the slots along with the holes. In most of the drawings, the hole table reports the size of the slot as the diameter (ø.23). But in a few drawings, the hole table reports it as a slot size (.23 x .31).

       

      Anyone have any idea what might be driving the inconsistency?

       

      Thanks, Daen