I am at a loss here. I am wondering if this sketch I created can be converted into sheet metal. I have looked at a few suggestions but none seem to fit this problem. I would like a single 2" sloped base for a tank I am designing. I would like to add flanges and unfold for laser cut. Any help would be greatly appreciated!
Sheetmetal works on 2D sketches
I would add a new 2D sketch linking dimensions to your 3D sketch to create flat pattern
Add diagonals to create triangle in your existing 3D sketch
Add sketch bends as required
I have edited your file
Exagerated offset
and attached it to this page
This allows use of your current geometry and adds additional flanges as well