AnsweredAssumed Answered

General question on translating orthographic view to solid model

Question asked by Patrick MacLane on Oct 13, 2011
Latest reply on Oct 13, 2011 by Wayne Tiffany

Hello,

 

I am currently learning Solidworks at my university. We have been given a few problem sets and I am currently practicing with developing solid models from 2 and 3 view orthographic models. This is the first time I have been asked to translate a two-view 2D drawing to a solid model and I am not sure what the standards are for top/bottom/left/right with two views. For the drawing below, is my selection of top and side accurate according to industry standards? This problem was given in our engineering graphics text.

 

2011-10-13_19-20-56_552.jpg

Thanks so much in advance!

Outcomes