2 Replies Latest reply on Oct 13, 2011 5:14 PM by Jerry Steiger

    Curve Driven Equation

    Christophe Cappelli

      I'm trying to create a kidney bean shaped sketch that I can cut out of a block. However, the equation I use won't complete the sketch. It always leaves a gap between the start and endpoint.

       

      Even if I try a simple circle in parametric form: xt =sin(t), yt= cos(t),  t1 = 0 and t2 = pi.

       

      Can SW not complete sketches that start and finish with the same endpoint?

       

      Thanks