I imported an assembly with a couple of sheetmetal parts from Inventor into Solidworks but I noticed the scale of the parts is actual * 100.
Any thoughts on why the scale would be off?
Thanks for any help,
I have been having the same issue for months and support cannot offer a solution! It's fine when it's a part, I can just scale it back but when it's an assembly that is not possible. There are no import scale options that I am aware of, only units but that will not change the scale. If a part comes in at 10m long, changing the units to mm it comes in at 10'000mm - same size.
It is an SPR and is fixed in SW 2011 SP5.0.... whenever that becomes available.
Did you set the units properly while importing them??
The scale and units have to be specified during export and import.
are you importing or file open a invetor native file? importing meaning iges, parasolid, sat or step.
Retrieving data ...