As you can see in the above picture, the 106 part number is shown as a fastener/hardware. How can I change the properties of the one below it to do the same thing?
If you don't have toolbox did you get this assembly from an outside
source that does?
Understand that toolbox parts are smart fasteners.
With Smart mates. If you undo these features and eliminate them
you should have your part back. I think the reason the macro in the first
link I gave you didn't work is because like you said you don't have toolbox.
that symbol does not mean it is a fastener. it means it is a Toolbox part.
see this thread https://forum.solidworks.com/message/224188#224188
Check out this thread and see if it helps you.
CONVERTING A TOOLBOX ITEM
We don't even use the toolbox and it still loads parts as toolbox items.
When I try to run that program... it says "Unable to get documentproperty 'IsToolboxPart' on file "xxx/175-0022.SLDPRT"
Not really sure where to go from here.
Yes, that's probably the reason. I started at my company after they decided to get rid of toolbox. That must be the reason.
Retrieving data ...