1 Reply Latest reply on Jun 26, 2006 5:55 PM by

    trimming a spline

    Guest Jun 26, 2006 5:55 PM
      offset splines, parabolas and ellipses cannot be trimmed according to SW
      • 309 Views
      • Categories: Sketching, SolidWorks
      • Tags:
        • trimming a spline
          Guest Jun 26, 2006 5:55 PM (in response to Guest )
          This is nuts!!!

          Unless I am missing something, we cannot trim an offset spline?????

          How dumb is that?? I have been able to trim offset splines and other lines in IDEAS and Pro/E and Microstation and even Impactxoft...maybe I am the only one that can use this option, or maybe I just don't have the right training when dealing with these issues...any helpful thoughts???

          Sorry, just needed to vent, yes I placed an enhancement request