6 Replies Latest reply on Sep 30, 2011 12:04 PM by Jeremy Feist

thickness analysis numeric display

Mark Kaiser Sep 12, 2011 8:24 AM

I get the below picture when I do a thickness analysis. It is very difficult to read the on screen values. Is this they way it is for everyone, or am I out of luck with my system?

System specs: HP p6370t, Win 7 Pro 64 bit SP1, Intel Core i5 650 3.2 Ghz, 6 GM RAM, ATI Radeon HD 4350 dRIVER 8.773.0.0 512 MB RAM.

I've adjusted some of the video driver settings, and I haven't come up with better results for the thickness analysis display values.

Re: thickness analysis numeric display

Mark Kaiser Sep 13, 2011 4:05 PM (in response to Mark Kaiser)

try #2
Like Show 0 Likes(0)

Actions
Re: thickness analysis numeric display

Jerry Steiger Sep 30, 2011 10:35 AM (in response to Mark Kaiser)

Mark,

Just so you won't feel totally abandoned, I tried the thickness analysis on my machine, which has an old and fairly cheap graphics card (Quadro FX 550) and runs SW2010. No problem with the numeric display. It's quite likely that 2011 makes more demands on the graphics card than 2010, so maybe my card will have problems if I switch. You probably don't want to hear it, but the most likely culprit for you is your graphics card.

Jerry Steiger
Like Show 0 Likes(0)

Actions
- Re: thickness analysis numeric display
  
  Mark Kaiser Sep 30, 2011 11:19 AM (in response to Jerry Steiger)
  
  Thanks Jerry.
  
  Anybody else out there want to try, use thickness analysis?
  
  Like Show 0 Likes(0)
  
  Actions
  - Re: thickness analysis numeric display
    
    Jeremy Feist Sep 30, 2011 11:33 AM (in response to Mark Kaiser)
    
    I've never actuall used the thickness analysis before - I don't see where to enable numeric display...
    
    Like Show 0 Likes(0)
    
    Actions
    - Re: thickness analysis numeric display
      
      Mark Kaiser Sep 30, 2011 11:44 AM (in response to Jeremy Feist)
      
      Move your cursor over the part and you'll get numeric feedback at your cursor location.
      
      Like Show 0 Likes(0)
      
      Actions
      - Re: thickness analysis numeric display
        
        Jeremy Feist Sep 30, 2011 12:04 PM (in response to Mark Kaiser)
        
        Numbers show up fine for me.
        
        Like Show 0 Likes(0)
        
        Actions

Go to original post