AnsweredAssumed Answered

about the Floxpress problem

Question asked by Kehui Chen on Sep 2, 2011
Latest reply on Jun 8, 2012 by Carmelo Rioflorido

Like • Show 0 Likes0
Comment • 2

Hi,

I am a new to the FloXpress and I am trying to do a pipe simulation in FloXpress, there are one inlet and 3 outlets, how can I define 3 outlets in the Floxpress? I tried but there still one outlet.

Thank you!

BEST

Hui

No one else has this question

Outcomes

2 Replies

Wayne Matus Sep 2, 2011 4:57 PM
Mark Correct
Correct Answer
FloXpress is limited to a single inlet and a single outlet. You would need to purchase the full product to analyze your pipe.
Like • Show 0 Likes0
Actions
- Carmelo Rioflorido @ Wayne Matus on Jun 8, 2012 12:47 PM
  Mark Correct
  Correct Answer
  Is there a way to change the density of water in FloXpress so I can at least simulate the plastic (i.e., molten resin) flow inside a mold cavity? Thanks.
  Like • Show 0 Likes0
  Actions

about the Floxpress problem

Outcomes

Related Content

Recommended Content