Hello,
I have hit a snag. How do I clean up these wrinkles on the wing tip? I colored them to make them obvious.
The file is attached too if someone wants to fool around with it.
ß!
Hello,
I have hit a snag. How do I clean up these wrinkles on the wing tip? I colored them to make them obvious.
The file is attached too if someone wants to fool around with it.
ß!
Never loft to a point.
See the iPhone model for an example of how to do this.
1. Wrap the perimeter with a boundary surface
2. fill the face with the fill surface tool.
When I find the model I will post it.
That was it! Wow, when it works, it works! I was able to simplify the model and acheive a better result. Wining!
Thank you for the help. The iPad file was key to understanding. I was able to glean a few good tricks from that.
Thank you so much for sharing.
ß!
Never loft to a point.
See the iPhone model for an example of how to do this.
1. Wrap the perimeter with a boundary surface
2. fill the face with the fill surface tool.
When I find the model I will post it.
https://forum.solidworks.com/thread/33764