Howdy,
I am struggling thru my first solo surfacing project. The demos and tutorials are great, but now the rubber is meeting the road.
The model is doing great. I am projecting curves and everything is working - until now. I can't figure it out. I believe all the curves are constrained. I have deleted and rebuilt the offending sketch a couple times and a few different ways. I've tried surface boundry, fill and lofted surfaces. They all give me no joy.
I would appreciate any help and advice.
Thank you,
Brent
The sketch along the faulty edge (dir2) may not connect to one of the dir1 sketches. All of your Dir1 curves have to actually touch the Dir2 curves. If you are putting a sketch right over an edge, don't do that. Just use the edge.
Tutorials and demos have a hard time conveying real world info like this.