AnsweredAssumed Answered

Model Open/Rebuild BUG SP 4.0

Question asked by Joseph Ankers on Jul 18, 2011
Latest reply on Jul 19, 2011 by Joseph Ankers

Just wanted to see if anyone else had this bug/if there was any info on it.

 

When opening an assembly, It opens fine you can zoom in, out. but you cannot select any surface, or part, untill you do a ctrl Q.

 

once you have done this it works fine, however it is Annoying!

 

 

Also there should be a area in the Forum for " feedback on New SP" if there is i could not find it?

Outcomes