3 Replies Latest reply on Jul 7, 2011 11:09 AM by Richard Lundy

Annoying message when opening assemblies after 2011 SP 4 upgrade

Richard Lundy Jul 7, 2011 10:54 AM

I installed SP 4 on one of my systems and now when opening an assembly I get a popup message multiple times say that the design table is empty and it is being removed from the feature tree. Has anyone else experienced this and is there a setting to change to eliminate it? I am holding off updating my primary system untill I can find a solution if one is available.

Re: Annoying message when opening assemblies after 2011 SP 4 upgrade

Scott McFadden Jul 7, 2011 10:59 AM (in response to Richard Lundy)

Richard,
See if this thread speaks to your issue.

https://forum.solidworks.com/message/234231#234231
Like Show 0 Likes(0)

Actions
- Re: Annoying message when opening assemblies after 2011 SP 4 upgrade
  
  Richard Lundy Jul 7, 2011 11:09 AM (in response to Scott McFadden)
  
  Scott,
  That is the situation I have. Having to run a macro on very assembly of every project I am working on is not something I can spend the time to do though. I will just not update to SP4 at this time on my primary system. I hope this gets corrected at some point in the future. I am going to contact my VAR and see what they can tell me.
  Thank you
  
  Like Show 0 Likes(0)
  
  Actions
  - Re: Annoying message when opening assemblies after 2011 SP 4 upgrade
    
    Scott McFadden Jul 7, 2011 11:11 AM (in response to Richard Lundy)
    
    Richard,
    That sounds like a good idea. But before you do, I would run the SW Rx tool and send them
    the recorded file for translation to see if that exposes anything.
    
    Like Show 0 Likes(0)
    
    Actions

Go to original post