6 Replies Latest reply on Jun 21, 2011 2:41 PM by Bonnie Caruthers

    can't quite seem to get the units correct dxf

    Bonnie Caruthers

      I am bringing in a dxf of a PCB as a part sketch. If I bring it in as inches it shows the correct dimension except the decimal in wrong place: should be 3.875 but shows 3875.00.

       

      If I try in mm, I get the same dim (3875.00).  I have also tried setting my units for drawing in both which makes no difference either.  What am I doing wrong?  This is the first time I have imported a dxf into SW

       

      thanks,

      Bonnie

       

      sw 2011 sp3