AnsweredAssumed Answered

Automating Sheet Metal Design

Question asked by Chris White on Jun 21, 2011
Latest reply on Jun 21, 2011 by Kenneth Barrentine

I am currently trying to automate a sheet metal design around a 10' x 5' x 1/16" sheet of aluminum to be formed into a docking system for a solar panel.  It is fairly stanrd as I drop the panel into the assembly and then creat a part inside the assebly for the sheet metal dock, however I need it to always use the full 5' of aluminum and I am trying to mate it so that it will do that, any suggestions?

Outcomes