3 Replies Latest reply on Jun 20, 2011 5:45 PM by Timothy Holman

    Importing results from flow simulation

    Adam Fain

      Hello,

       

      I'm attempting to do a static stress analysis on a certain geometry using the fluid pressure from a flow simulation study as the applied load.  I keep getting an error stating that "no loads are applied" when attempting to run the study.  There is not a lot of information available on why this occurs.  There is a tutorial with a ball valve explaining how to export fluid results into simulation.  I can get the tutorial to work, but not my own project.  I follow the exact same steps so I don't know where the difference is.  Is the error possibly due to the meshing?

       

      Thank you