4 Replies Latest reply on Jun 16, 2011 11:13 AM by Scott McFadden

    circumference dimension

    Mark Greenwell



      Is there a way, when in a drawing to dimension a pipe to show its circumference.


      I know how to do it for an arc (end point, end point, arc line). But I cannot figure out how to do it for a full circle.


      For example if I have a 500mm OD tube the circumference would be PI x D = 3.142 x 500 = 1571mm.


      How can I show this 1571 as a dimension, or how do I set a note up to show this figure.




      Mark (SolidWorks 2011 sp3)