AnsweredAssumed Answered

Wierd corners between flanges.  What is SW doing?

Question asked by Ryan Bowman on Jun 14, 2011
Latest reply on Jun 14, 2011 by K. Hampton

My office is moving from CoCreate to SolidWorks 2011 and I'm starting to convert an existing product into SW.  I've run into a wierd corner treatment between two adjacent flanges.  Rather than a straight cut between the two flanges, SolidWorks is creating a slanted cut that stretches the bend.  Check out the attached JPEGs and part file.  What's going on here?  I've never see software make corners like this.  Is there a good way to control how these corners are formed so I don't end up with a goofy flat part?

Outcomes