Any idea how to do this?
You talking about this?
No I was able to set up the pre defined views but the views that are projected off of the parent view are not linked back to the parent view (as far as configurations go; if I change the configuration of the parent view I would like the projected views to follow suite).
As far as I can tell this is something that can only be set once that view is populated (in other words cannot be set in a template). I would more often than not, like the projected views to be in the same configuration as the parent view; the only exception being sheet metal parts (I like to make the parent view a flat pattern configuration while leaving the other three views in their bent configuration).
I have looked into predefined vies, but in all the formats I have setup I have never done them.
Did you try redefining them in your drawing templates?
Yes several times with no luck, the option just isn't there which surprises me.
Yes, me too.
Have you tried creating a brand new drawing template?
Do you mind posting your template so I can have a look at it?
Retrieving data ...