AnsweredAssumed Answered

Unable to insert an assembly into another assembly if a part is rolled back

Question asked by Brian Hoerner on Jun 8, 2011

Folks,

 

I may have never had this happen before, so it may be the "norm" with SW.

 

A user came to me when trying to insert an assembly into another assembly, the intended sub-assembly would not show up in the selection window, and when I browsed to the OS for him the error came up that the assembly was not available because a part was in a rolled back state.  I found there were two parts, rolled them forward and then he was fine.  And individually I can insert the rolled back part into the assembly.

 

My question is, have others seen this, is it a normal function...and if so.........WHY!!!!!!!!!!!!!!!!!!!!!

 

 

 

Thanks,

Brian

SW2010 SP4.0, W7 x64

Outcomes