AnsweredAssumed Answered

Hole Wzd - Config depth of csink instead of outer Ø

Question asked by Kris Rowlands on Jun 3, 2011
Latest reply on Aug 4, 2011 by Michael McKee

Is there a way, in the hole wizard, to configure a csink hole that specifies the csink depth and angle instead of the csink outer Ø and angle?

 

This is basically a thru hole, with a 120° csink to a specified depth. I know I can do a hole, then a cham, but I want to do it all in the hole wizard. Is there any way?

 

Thanks so much!

Outcomes