AnsweredAssumed Answered

SELECTION OF REFERENCES FOR WIDTH AND SYMMETRIC MATES WHILE REPLACING A COMPONENTS

Question asked by RAM KIRAN MYANA on May 30, 2011
Latest reply on May 31, 2011 by RAM KIRAN MYANA

Hello Everyone!!!

This is my first Discussion. May be very simple to all of you. I have a shaft with slot for snap ring around it. When I try to replace shafts (using replace components option) with another shafts which has a slot It is not allowing me to replace its references. I use width mate or symmetric mate for snap rings.

 

Thanks.

RAM

Outcomes