AnsweredAssumed Answered

Added CBore in assy, end condition is 0 material

Question asked by Kris Rowlands on May 25, 2011
Latest reply on May 26, 2011 by B. ter Stege

When trying to do this cbore, either thru legacy hole or custom sizing, the feature does not take. I think it's because of the 0 material condition that exists after the bore goes in (which is how it's supposed to be). Pleae see image.

 

The feature shows in my tree, but I cannot see it on the assembly. I can see the preview when in the feature, but once I exit the feature, it disappears.

 

Please advise.....I should be able to do this...........or does SW stop me when it sees that a cbore is leaving a 0 material condition? Argh.....

Attachments

Outcomes