How to create a Scarf-Cut in Flat Pattern

Discussion created by Guest on Sep 21, 2006
Eddie -
I was surprised by the difficulty of this! At least in SW06.

The best I came up with was a sketched bend that comes close, but it has 2 little tiny flats (someone else may have already suggested this - if so, my apology). IMHO this is better than the concave artifact of the lofted bend.

Gerald Davis CSWP
SW06 SP5.0 Office Professional
2GB / Opteron 175 / FX3400 / ASUS A8N32-SLI
http://www.cosug.com Colorado SolidWorks User Group

Outcomes