AnsweredAssumed Answered

New to SW's, simple sheet metal question

Question asked by Rick Freeman on May 24, 2011
Latest reply on May 24, 2011 by Wayne Tiffany

I'm VERY new to SW's (company just bought it, training hasn't happened yet).  But...can I bend a flat piece using sheet metal?  In this certain case, it's makes more sense to bend it from the flat rather than model it already bent and then create the flat pattern.  If so, what are the steps?  Thanks!

 

I've attached a file...each end (with hole) gets bent 49.79 degs.  The top pair of ears gets bent +49.79 and the bottom pair is bent -49.79 degs.  Hope that's clear.

Attachments

Outcomes