9 Replies Latest reply on May 12, 2011 7:59 AM by Scott McFadden

    help "widening" a part please?

    Andy Lang

      Hi all,

       

      ok stupid problem. I have two cases and each have matching angles etc, I need to widen both parts to move the left and right geometry out a bit.

       

      I started by opening it up as its basic sketch - putting two vertical lines top to bottom and cut out the line in the middle. logic being to then dimension the sides accordingly and put a line back in after.

       

      I can make some photos up as i understand that prob does make any sense?!

       

      Many thanks in advance,

       

      Andy