AnsweredAssumed Answered

Split sheet metal part into multibody.

Question asked by Clint Stahl on May 5, 2011
Latest reply on May 5, 2011 by Clint Stahl

Can someone please tell me if the following is possible. If you look at the image or part I have attached you will notice it's a one piece part. I can flatten it and it's all one piece. However what I'd like to do is avoid having to draw in the top 45deg connection points and all that stuff with manual sketches. I can't bend this part because it's too deep. Is there anyway I can seperate the short side from the longer sides the way it is. Basically make a multibody part out of it.

Attachments

Outcomes