AnsweredAssumed Answered

Configurations^5

Question asked by Tom Strohscher on May 3, 2011
Latest reply on May 3, 2011 by Don Vanzile

How can I limit the number of configurations I need but still show parts in different positions?

 

I would like to show the parts in a mold assembly in it's open and closed states.  (The same applies to cylinders extended or retracted.)  This is straight forward and I typically make two configurations.

 

My problem is that I would like to show the states of the mold equipment on an assembly drawing where the molds are 5 or 6 sub-assembly layers deep.

 

Is there any way around creating an open and closed state in each sub assembly so I can show the molds open and closed on the main assembly?

Outcomes