Does anyone know how to change the default file naming protocol from starting at 00_filename.dxf to 01_filename.dxf when doing a save as to dxf for drawings?
Checkout this thread.
It points to the Solidworks task scheduler.
TS adds a suffix instead of the prefix that I have been using in the past.
There are two ways using a macro.
1 Add a property with the required name and then use the macro to save with property as file name
2 Write the codes in such a way that it will increment the file name.
It was worth a shot because that thread looked like what you were trying to do.
Scott thanks for the information though. I am just going to go ahead and save out the entire drawing as one dxf file.
Oh, your welcome.
Something to fall back on I guess.
Retrieving data ...