AnsweredAssumed Answered

FLAT SIZE???

Question asked by Robert Moore on Apr 19, 2011
Latest reply on Apr 19, 2011 by Deepak Gupta

I am having a problem with flattening some sheetmetal parts.

 

If I use "run import diagnostics" and then "proceed with feature recognition" I get a different flat size then if I just insert bends..........does not matter the size of the part or how many bends, both "length & width" come out wrong........running Solidworks pro 2010........same K-factor on both parts.........

 

Anyone else get this problem?????

 

DID NOT have this problem in Solidworks 2008.........

 

Searched the forum for this problem, but could not find any solutions........

Outcomes