I am studying the motion simulation, but the Motion Manager toolbar is not available on the screen, I have tried check and uncheck in view menue, but the toolbar which contain calculate motion, animation etc commands is not visible. Can somebody help in this regards
Thanks
Arshad
Welcome to SW forums Arshad.
Sometime the toolbar is being dragged down unknowingly. Check attached video and try to replicate if that fixes the problem.
Also read this post for your future reference: Forum Posting
The problem might be deeper than that. Last week I found my previously available toolbar was simply not on the menu.
Hi Roland,
Please make sure that your Motion toolbar is not collapsed. If it is collapsed, you can restore it using this solution - https://forum.solidworks.com/message/206837#206837
Also make sure that you have an assembly loaded in SW when switch to a Motion Study tab. If you have a part loaded in SW instead of an assembly, it cannot be simulated, so the study type pull-downs are disabled.
Regards,
Shrikant
Thanks. I'll have to give that a try.
This is what I have suggested via my video
Thankyou so much Deepak you have given me exact answar. I appreciate you.
Thanks once again.
Arshad
Welcome to SW forums Arshad.
Sometime the toolbar is being dragged down unknowingly. Check attached video and try to replicate if that fixes the problem.
Also read this post for your future reference: Forum Posting