John Thornton

Run Macro

Discussion created by John Thornton on Mar 24, 2011
Latest reply on Mar 24, 2011 by Filipe Venceslau

I just upgraded to SP3.0 and when I run a macro that creates a part the dialog box prompting for a location to save the part in comes up under SW so you think SW has locked up as it no longer responds to input with that dialog box up. This is the first time I've seen this... I'm not sure if I have ran a macro since installing Windoz7 or not so I can't say which it is.

 

Thanks

John

Outcomes