AnsweredAssumed Answered

Phantom arc after deleting fillet

Question asked by Eric Snyder on Mar 18, 2011
Latest reply on Mar 21, 2011 by Kelvin Lamport

A sketch was created by offsetting a solid at the base. When the solid was offset there were fillets on the corners. The fillets did not belong so they were suppressed. Now the sketch that has the offset is messed up with these red circles that are leftovers from when the fillet was there. I cannot select these and they do not disappear on rebuild. Does anybody have any suggestions on how to eliminate the fillets without blowing away the sketches and starting over on them?

 

Before:

phantom arc 1.jpg

 

After:

phantom arc.jpg

Outcomes