AnsweredAssumed Answered

d.t. DRIVING ME NUTS. When will SW get them right?????

Question asked by Mike Lydon on Mar 11, 2011
Latest reply on Mar 17, 2011 by Mike Lydon

I have a simple steel lug with configurations. Configurations vary the length and width, the size and location of a hole and the dimensions of two chamfers. Each chamfer is created with distance x distance method. When I try to set the chamfer dimensions in the design table, no matter what I set them to, initially, after closing and reopening the d.t. all of the chamfer dimensions revert to 10mm. I spent all day yesterday fighting with this with absolutely no success. I tried editing the feature in the tree, and then saving. Check the design table, all looks good. Close and reopen the design table, all chamfer dimensions are back to 10mm. Can anyone shed some light on this problem?

Outcomes