Hi everyone we have a lot of sheet metal parts that have a large bend radius in them and we bump bend them. Is there a way to control the quantity of bend lines
as in a lofted bend but in a sketched bend? These parts cannot be lofted and I would hate to have to calculate all of them out
Thanks Troy But somehow I need to try to keep the original geometry these are old parts. Thanks for the reply
Hi Neal,
As Troy said there are no easy SW solutions
But there are a couple of ways round it ( it wouldn't be SW if we couldn't have a work-a-round )
Here are 2 examples
Michael
Thanks but the problem I have is that the parts are old parts and they are in a lot of assemblies. I was hoping not to change the geometry
so I did not have to go in and fix all the mates. but that is a good work around Thanks!!
The only way I can think of doing this is to create the part as a solid then convert over to sheet metal. Unfortunately there is no tool to create/convert one bend into multiple bends.