Quick view is read only, the drawing state comes from saving last time, i.e. it doesn't update with model.
So I think you can open up the drawing the conventional way, make sure everything is ok, then save the drawing.
The reason is that the drawing doesn't update with model at the same time.
Thanks for your response. I knew it was a read only, but interesting that
it keeps the last save profile and not what currently is. Maybe through
ignorance I was mislead here at work. I am going to look into this.
Checked into it and apparently I just needed to update the quickview
edition because production was seeing this version.
Thanks again for your response.