1 Reply Latest reply on Feb 23, 2011 9:13 PM by Kelvin Lamport

    Change association of drawing from part to an assembly and vice versa

    Lope Timajo

      Hi everyone,

       

      A drawing was created from a part model document. With some design change, some fixtures need to be attached to this part and so an assembly model document (with the part and the attached fixtures) was created. Problem is the drawing that was previously created is only associated with the part doucment. Is there a way to change the association of a certain drawing from part to an assembly? And/or an assembly drawing to part drawing?

       

      Thanks in advance.

       

      LT