im looking for suggestions on the best way and quickest way to built a bycle frame in weldments.
or where could i find a tutorial about weldments will be appreciated ,
start with the tutorials in solidworks (Help -> solidworks tutorials).
Welcome to the forum,
On top of weldments you might also want to look into sweeps and lofts in the Solidworks
tutorials. Also check out youtube I saw some on there.
Here is an instructional link on creating a bicycle frame in Solidworks.
Yes that approach works fine. You will run into trimming issues due to tube size, the way around this is to manually trim with cut-extrudes and/or surfaces.
Start with a 2D layout sketch with the frame geometry, lay a 3D sketch over that with the seat and chainstays.
Retrieving data ...