I was attempting to update a design table external to SW and had a crash.
Keven, this had a know error that many users have seen earlier. Here is more details on it and some possible solution mentioned in this post Re: design table problem
Also read this post for your future reference: Forum Posting
I have been getting that error message since I started using 2010.
Sometimes it happens after only going once into the design table and other
times after 2 or 3 times. Then sometimes it never happens again in that session.
I end up closing out of Solidworks completely and starting a new session.
After doing this a couple of times is when I can reedit the DT unlimitedly.
FYI, This also happens with Excel 2003 as well.
Retrieving data ...