AnsweredAssumed Answered

Help ripping a sheet metal cone with a helix

Question asked by Reno Simpson on Feb 16, 2011
Latest reply on Feb 18, 2011 by Reno Simpson

One way was using a helix to "swept cut" and the other was cutting a flat pattern

 

Also how do I align the helix starting with sketch 1 circle and ending on sketch 2 circle with 1/4 twist?

 

PS you'll notice a gap in my revolve, it's the only way SW will create a flat pattern. I had 360* when doing the helix cut.

 

I've tried this a few ways but no luck.

Attachments

Outcomes