AnsweredAssumed Answered

Sheet Metal Part Showing Up As Structural Member in Drawing

Question asked by Dean Baragar on Feb 14, 2011
Latest reply on Feb 14, 2011 by Dean Baragar

Have a look at the photo I have attached. The file I have opened should be a flat pattern of a sheet metal part (as shown by the preview on the right screen when I first selected the file to open). When the file opens in SW, there is no longer a sheet metal part, but an angle iron. The bend lines still exist but they aren't referencing anything.


Several files are doing the same thing. The strangest thing is that when I delete the drawing, recreate it, and save it all is well; but when I open it up again, it does the exact same thing.


Can anyone shed some light on what is happening? It's too early in the week for errors like this =\