5 Replies Latest reply on Feb 1, 2011 10:27 AM by Scott McFadden

    Property Tab Builder - Using Checkboxes

    Dean Baragar

      I am revamping the property tab a little bit and would like to add in some checkboxes to append some more information to my parts. This information I would like to show up in my bill of materials and my drawing template. Basically the checkboxes will include the processes that make the part (sawing, drilling, torching, painting ect. ect.). I have not been able to find much in the forum to do with checkboxes and radio buttons so hopefully someone has had some experience with these. I have attached a picture of my property tab.

       

      As far as the BOM goes I would like to add a column titled "processes" and have a list of codes stating the processes (ex. if a part is sawed and drilled it would have 'S, D' in that column). In my part drawings I would like to have a similar checkbox list in my template to indicate the processes to make the part.

       

      Thanks for any input!