I have just loaded Solidworks 2011 sp2. I have a problem when i select the front face of my model and select convert entities. A new sketch of the edges is created but the problem is that all the radii are changed to splines.
use the measure tool to verify that the axes of the radii are perpendicular to the sketch face.
The original part is drawn on X.Y, Z on 0,0,0 on the front plane. The sketch that was created with convert edges is also on the front plane. I have done this hundreds of times before. It seems to be software related as another user who has also installed SolidWorks 2011 has the same problem.
Very interesting. I will have to investigate.
Works fine for me with SW2011-SP2.
Can you post a sample part?
I found the problem. The problem is caused by an earlier step where shrinkage was added using the scale function. The problem is the scaling is not been carried over to other configurations. eg. The shrinkage is set at 1% - uniform scaling - all configurations in config called shrinkage. However, the scale factor somehow changes to 0% with uniform scaling unchecked in the other configurations. Any solutions?
Retrieving data ...