Is it possible to merge to surfaces together and then perform a cut in a solid model with the merged surfaces ?
Yes, use Cut with surface option
I tried that, but it didn't work. I still need to know if you can merge 2 surfaces together that intersect each other. When I tried cut with a surface, it failed becasue I had 2 extruded surfaces coming from different directions
Sounds like you need to do a trim then a surface knit. Then you should be good to go.
Sounds like you need to knit the surfaces with the Merge Entities enabled…
Then split it with the surface.
I tried it with the knit and turned the merge on and it failed. I also loosened up the tolerances and it still failed
Can you post the file?
The surface boundaries need to extend beyond the solid in all directions. Maybe extend the surfaces in addition to knitting them.
ok.. didn't know that.. I'll try that for sure
Retrieving data ...